Temperature Adjustment - Kenmore 911.41775 El Manual Del Propietario

"DOIT YOURSELF"
TEMPERATURE
1. Press and hold down
both the BAKE and
BROIL pads for 3
seconds, untiethe
display shows SF.
ADJUSTMENT
You may feel that your new oven cooks
• differently than the oven it replaced. We
recommend that you use your new oven
a few weeks to become more familiar
with it, following the times given in your
recipes as a guide.
If you think your new oven is too hot
(burning foods) or not hot enough
(foods are undercooked) you can
adjust the temperature yourself. The
appearance and texture of foods is a
better indicator of oven accuracy than
oven thermometers; These
thermometers can vary by 20-40
degrees. In addition, the oven door
must be opened to read these
thermometers. Opening the door will
change the temperature of the oven.
To decide how much to change the
temperature, set the oven temperature
25 degrees higher (if foods are
undercooked) or 25 degrees lower (if
foods are burning) than the temperature
in your recipe, then bake. The results of
this "test" should give you an idea of
• how much the temperature should be
changed.
..I-
1
Press the BAKE pad.
A factory set 2 digit
number will show in
the display, usually
00.
TEMP
@
If you think the
oven is not hot
enough,
3a. Press the TEMP UP
arrow pad to
increase (+) the
temperature up to
+35°F.
3b. Press the TEMP
DOWN arrow pad to
decrease (-) the
temperature down to
.35°F,
4. Press the START
pad,
This increased or decreased
temperature setting will remain in
memory until the above steps are
repeated. A power failure witl not "
affect this setting.
The broil and self-clean temperatures,
will not be affected.
25