Tones - Kenmore 911.41775 El Manual Del Propietario

OPERATION
OvenControl, Clock and Timer
Your new control has a series of tones
that will sound at different times. These
tones may sound while you set the
control for an oven function, Oi"at the
end of the oven function. It will also alert
you there may be a problem with the::::_i: '
functions. Below are the types of tones
and a brief description of each.
TONES WHILE SETTING THE
CONTROL--When you press a touch
pad you will hear a beep. This beep will
let you know you have placed enough
pressure on the pad to activate.it. (The
arrow pads do not beep.)
END OF TIMED CYCLE TONE--At
the end of a timed cooking function,
you will hear 3 short beeps followe d by
1 beep every 6 seconds. Thisbeep will
continue to sound every 6 seconds,
until the CLEAR/OFF pad is pressed
or you may select the special feature to
cancel this 6 second beep from
sounding at the end of future CYCles.
TO CANCEL THE 6 SECOND
BEEP
1. Press and hold the BAKE and:
BROIL pads, at the same time
for 3 seconds, until the display
shows "SP.
2. Press the KITCHEN TIMER
0N/OFF pad. The display will show
"@ON BEE_' (continous beep).
3. Press the KITCHEN TIMER
ONtOFF pad again. The display will
show "BEEI_' (beep canceled).
4, Press the START pad to cancel the
6 second beep and leave the
special feature mode.
If you would like to return the 6 Second:
beep, repeat steps above until the:
display shows yourch0ice and p:ress
Start.
ATTENTION TONE--This tone will
sound if you make an error or an
.oversight is'made while setting an oven
function;
Exampies would be:
a, Setting a clean cycle and the oven
door is not.properly closed.
b. Setting function and not pressing
Start.
c. Pressing an additional functiOn pad
without first setting a temperature or
time.
d. ERR will flash if you set an invalid
temperature. Press the CLEAR/OFF
pad.to clear the Co'ntrol and reset
your oven function:
Any of these can be quickly identified
by watching the display.
PREHEAT TONE--When you Set: an
oven temperature, Lheoven
automatically starts to heat. When the
temperature insidethe oven reaches
the temperature you have set, a-lone -
will sound to let youknow the oven is
ready for bak!ng.
If you set.an oven function and the
control beeps while the display ss
flashing "F,' an'd a number or letter-:
Such as "F-4" or "Fr' there may be a
problem with the control or oven.
Simply press the CLEAR/OFF pad and
wait about an hour. Try setting the
function again, If the code repeats, write
down the flashing code and call for
service. Tell the technician what code
was flashing.
9