Product Description; Important Safeguards - TZS First AUSTRIA FA-5406-7 Manual De Instrucciones

INSTRUCTION MANUAL
JUG KETTLE
SAVE THESE INSTRUCTIONS!

PRODUCT DESCRIPTION

2
1
3
4
5
6
1. Cover
2. Soft Eject Button
3. ON/OFF & Temperature control Switch
4. MAX Water Level Indicator
5. Cordless Power Base
6. 360° Connector

IMPORTANT SAFEGUARDS

When using your kettle, basic safety precautions
should always be followed, including the following:
1. Read all instructions carefully, even if you are
familiar with the appliance.
2. Close supervision is necessary when any
appliance is used by or near children.
3. Before connecting the kettle, check if the
voltage indicated on the appliance corresponds
with the mains voltage in your home. If this is
not the case, contact your dealer and do not
use the kettle.
4. Switch off and unplug from the outlet before
filling, emptying or cleaning, or when not in use.
5. Do not overfill as boiling water may be ejected.
The maximum level is marked inside the kettle.
6. Do not operate or place any part of this
appliance on or near any hot surface (such as
gas or electric burner or in a heated oven).
7. Do not let the cord hang over the edge of a
table or counter. Do not let the cord touch hot
surfaces.
8. Never yank on the cord as this may damage
the cord and eventually cause a risk of electric
shock.
9. If the supply cord of this appliance is damaged,
it must only be replaced by a repair shop
appointed by the manufacturer, because special
purpose tools are required.
10. Avoid touching hot kettle surfaces - use the
handle and the knobs.
11. To avoid possible steam damage, turn the spout
away from walls or cabinets when operating the
kettle.
12. If operated on wood furniture, use a protective
pad to prevent damage to delicate finishes.
13. To avoid scalding, always ensure the lid is
correctly positioned before operating.
14. Scalding may occur if the lid is removed whilst
heating.
15. Extreme caution must be used when moving the
kettle containing hot water. Never lift the kettle
by it's lid. Always use the body handle.
16. Do not switch your kettle on if it is empty.
17. To protect from electrical hazard, do not
immerse this kettle or cordset in any liquid.
18. Use the kettle only with the supplied base unit.
Do not use the base unit for other purposes.
19. To protect against fire, do not operate in the
presence of explosive and/or flammable fumes.
20. A kettle should not be left connected to a wall
socket when the room temperature is likely to
fall to outdoor winter temperatures. At sub-zero
temperatures the automatic control thermostat
may reset to boil and energize the element.
21. Do not use the kettle for any purpose other
than heating water. Other liquids or food will
contaminate the interior.
22. This product has not been designed for any
other uses than those specified in this manual.
23. This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or lack
of experience and knowledge, unless they have
been given supervision or instruction concerning
use of the appliance by a person responsible for
their safety.
24. Children should be supervised to ensure that
they do not play with the appliance.
WARNING:
Compare the local voltage with the voltage declared
on the device.
INSTRUCTIONS FOR USE
1. Before first use, fill the kettle with clean water to
maximum capacity and boil. Discard the water
and repeat.
2. The kettle should always be unplugged when
filling or adding water.
3. Fill the kettle with water to the desired level. Do
not overfill or there will be a risk of spillage or
spitting. Do not forget to close the lid after filling,
otherwise the kettle will not automatically switch
off after use.
4. Do not fill with less than 0.5 litre of water (up to
„MIN" indication) to prevent the kettle runnning
dry while operating.
5. Do not fill with more than 1.8 litres of water (up
to „MAX" indication).
6. An automatic safety cut-out has been fitted for
protection against overheat ing. It will operate
if the kettle is switched on when containing
insufficient water. Always ensure that the water
inside the kettle covers the minimum mark.
If the automatic safety cut-out has operated,
disconnect from the power outlet and allow the
kettle to cool down for 5 to 10 minutes. Then
2
refill with water and switch on - the kettle will
then boil and cut off as in normal operation.
7. Place the power base on a dry flat surface.
8. Place the kettle on the power base.
The electrical connections will be made
automatically as the kettle slides onto the power
base.
9. Plug the cordset into an earthed power socket.
10. Press the button, the kettle heats up and
a beep sounds. After the water has boiled the
indicator turns off and the buzzer sounds some
beeps.
11. When the water has boiled, the kettle will switch
off automatically.
12. Do not remove the kettle from the power base
without switching off first.
13. To pour water, lift the kettle from the power base
and pour.
ADVANCED OPERATION:
Keeping temperature mode
1. Press and hold the (ON/OFF) button for 2
seconds, a beep sounds from the buzzer and
the kettle is in "keeping temperature mode".
The red illumination indicates that the kettle is in
"boiling water mode".
It will keep the temperature above 85°C for 2
hours.
2. Press the button (+/-) once, the green
illumination indicates that the kettle is in "60°C
mode". It will keep the temperature at 60°C for 2
hours.
3. Press the button (+/-) twice, the blue illumination
indicates that the kettle is in "70°C mode". It will
keep the temperature at 70°C for 2 hours.
4. Press the button (+/-) 3 times, the yellow
illumination indicates that the kettle is in "80°C
mode". It will keep the temperature at 80°C for 2
hours.
5. Press the button (+/-) 4 times, the purple
illumination indicates that the kettle is in "90°C
mode". It will keep the temperature at 90°C for
2 hours.
Setting temperature only once
1. Press the (ON/OFF) button shortly, a beep
sounds from the buzzer and you can set now the
temperature. The red illumination indicates that
the water will be boiled.
2. Press the button (+/-) once, the green
illumination of 60°C turns on.
The heating element will switch off when the
water temperature reaches 60°C.
3. Press the button (+/-) twice, the blue illumination
of 70°C turns on.
The heating element will switch off when the
water temperature reaches 70°C.
4. Press the button (+/-) 3 times, the yellow
illumination of 80°C turns on.
The heating element will switch off when the
water temperature reaches 80°C.
5. Press the button (+/-) 4 times, the purple
illumination of 90°C turns on.
The heating element will switch off when the
water temperature reaches 90°C.
After use, please remove the plug from the
power outlet.
HOW TO CARE FOR YOUR KETTLE
Wipe the exterior of the kettle with a soft, damp
cloth or sponge. Remove stubborn spots with a
cloth moistened with mild liquid detergent. Do not
use abrasive scouring pads or powders. Never
immerse the kettle in water or other liquids.
From time to time depending on the nature of
your water supply, a lime scale deposit is naturally
formed and can be found mostly adhered to
the heating element and reduces the heating
capacity. The amount of lime scale deposited (and
subsequently the need to clean or descale) largely
depends on the water hardness in your area and
the frequency with which the kettle is used.
Limescale is not harmful to your health. But if
poured into your beverage, it can give a powdery
taste to your drink. Therefore, the kettle should be
descaled periodically as indicated below:
DESCALING
Descale the kettle regularly. With normal use, at
least twice a year.
1. Fill the kettle up to „MAX" with a mixture of
one part ordinary vinegar and two parts water.
Switch on and wait for the appliance to switch
off automatically.
2. Let the mixture remain inside the kettle
overnight.
3. Throw the mixture away next morning.
4. Fill the kettle with clean water up to „MAX" and
boil again.
5. Throw away this boiled water to remove any
remaining scale and vinegar.
6. Rinse the inside of the kettle with clean water.
360° CONNECTOR BASE
The 360° connector between the kettle and its base
means that the kettle can be located at any point on
the base. This is ideal for left and right-handed users
as the kettle can be positioned conveniently on your
kitchen counter.
TECHNICAL DATA:
220-240V • 50/60Hz • 1850-2200W
Environment friendly disposal
You can help protect the environment! Please
remember to respect the local regulations: hand
in the non-working electrical equipments to an
appropriate waste disposal center.
3