Safety Rules; General Safety Rules - Promax TG-140 Manual De Instrucciones

USER'S MANUAL. TG-140

2 SAFETY RULES

2.1

General safety rules

*
The safety could not be assured if the instructions for use are not closely
followed.
*
This is a class I equipment, for safety reasons plug it to a supply line with the
corresponding ground terminal
*
This equipment can be used in Pollution Degree 2 environments.
*
When using some of the following accessories use only the specified ones to
ensure safety.
Power cord
*
Observe all specified ratings both of supply and measurement.
*
Remember that voltages higher than 70 V DC or 33 V AC rms are dangerous.
*
Use this instrument under the specified environmental conditions.
*
The user is not authorized to open the equipment.
Any change must be done only by specialized technicians.
*
The negative of measurement is at ground potential.
*
Do not obstruct the ventilation system of the instrument.
*
Use for the signal inputs/outputs, specially when working with high levels,
appropriate low radiation cables.
*
Follow the cleaning instructions described in the Maintenance paragraph.
02/2013
CA005
Page 5