Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
7.1
Software Updates
The TG-140 software can be updated by connecting to the Promax Software
Updates Server.
There are three equipments involved in the software update of the TG-140: the
TG-140, the user's computer and the Promax Software Updates Server.
The TG-140 must have a valid IP address so it can access the Internet. The user
must know the address of the TG-140 and the address of the Promax Software Updates
Server. The user uses his User Computer to connect to the TG-140 and to tell the
TG-140 which is the address of the Promax Software Updates Server.
Computer
The steps to do a Software Update go like this:
-
The user installs the MS Windows software in his computer. See the
corresponding section of this manual.
-
The user sets up an IP for the TG-140. See corresponding section of
this manual.
-
In the User Computer, the user goes to Start/Programs/Promax_TG-
140/TG-140 Update and a little window pops up. The user introduces
the IP address of the TG-140 in this windows and presses OK.
-
After pressing OK the little application will try to connect to the TG-140
and if it succeeds another window will appear. This second window is a
little application running on the TG-140. The user has to introduce the
IP address of the Promax Software Updates Server and press OK. The
TG-140 will try to connect to the supplied IP address to update itself. A
text window will appear to show the progress.
Page 20
User
Promax Software
Updates Server
Figure 10.-
Figure 11.-
USER'S MANUAL. TG-140
TG-140
02/2013
Publicidad
Capítulos
Tabla de contenido
