Restoring The Hard Disk - Promax TG-140 Manual De Instrucciones

USER'S MANUAL. TG-140

9 RESTORING THE HARD DISK

With the TG-140 turned off insert the Rescue Compact Flash at the rear side
(figure 5 - 10).
Connect a screen, mouse, and keyboard. Turn on the TG-140 and press
Del/Supr. to enter into the BIOS configuration. Check the following BIOS settings so
that the computer boots from the Compact Flash:
Advanced BIOS Features/Hard Disk Boot Priority/ 1. Compact Flash
Advanced BIOS Features/Hard Disk Boot Priority/ 2. Hard Disk
Save the BIOS settings and it will reboot.
The Rescue Compact Flash will boot and the Installation System will start.
With the arrows of the keyboard go to Menu/Install and press Return. Select:
Push return.
Data in /dev/sda will be wiped. Are you sure about this? [y/N]
Push "y" and wait.
The installation lasts about 10 minutes. Once the installation is finished turn off
the TG-140. Then remove the Rescue Compact Flash and restart the TG-140.
Reconfigure the BIOS settings so that it boots from the hard disk first and save the
settings.
If the word disc is not broken down
If will be ready to be used.
02/2013
Device to install: /dev/sda
Boot: /dev/sda1
Page 23