Basic Operation; Advanced Operation - Klip Xtreme Bravo II Manual Del Usuario

: Touch this button to play the previous track, in Bluetooth
7.
card modes.
: Touch this button to play and pause media, in Bluetooth
8.
card modes.
: Touch this button to play the next track, in Bluetooth
9.
Built-in microphone: Use it for hands-free calling and conferencing.
10.
Rear panel
Micro-USB port: Plug the supplied USB cable into this port to recharge the
11.
built-in battery.
card slot. Use it to playback music files stored in the memory.
™
12. Micro-SD
Auxiliary 3.5mm port: Allows the connection of any device equipped with a
13.
3.5mm audio jack (for wired playback).
Power button: Use it to turn the device on and off.
14.
Reset button: Use to return the speaker to its factory default settings.
15.
III. Basic operation
• Use the supplied USB cable to charge your portable speaker directly from your
computer or device with a standard USB port.
• Make sure that the speaker is fully charged before using it for the first time.
• The portable speaker battery has to be initially charged for at least 2 hours.
Thereafter, the battery will take from 1.5 to 2 hours to recharge.
• While charging, the battery indicator LED lights up solid red. When LED turns
off, it means that the battery is fully charged.
To turn on the speaker, press and hold the power button for several seconds.
•
Press and hold the power button once more to turn off the device.
and SD
™
®
and SD
™
®
and SD card modes.
™
®
IV. Advanced operation
Note:
Before installing this product, please make sure your device has the built-in
feature available.
Bluetooth ®
Pairing the speaker with your mobile device
Make sure the speaker is off.
1.
Set your Bluetooth device to "discover" the wireless speaker.
2.
®
Place both devices not more than one meter away from each other.
3.
Switch the speaker on by pressing the power button located on the back. The
4.
blue LED starts blinking accompanied by a tone, to indicate that the device has
entered into the pairing mode and is ready to be detectable for the first time.
On your mobile phone, tap the newly discovered audio device (KWS-613)
5.
displayed in the Bluetooth list.
®
When the phone asks if you want to pair with the wireless speaker, click Yes
6.
or Ok to accept.
If you have a lower Bluetooth version, you may be prompted to enter the
7.
®
passkey 0000 (4 zeros).
If pairing is successful another tone will be heard, making the LED change to
8.
solid blue to confirm that the connection has been established.
If after 60 seconds the pairing process fails, please repeat steps through 6
9.
described above.
The speaker will enter into standby mode automatically after a short period of
10.
inactivity.