Manual Installation Using Arp And Ping In Windows - Axis 292 Guia De Instalacion

Page 8

Manual Installation using ARP and Ping in Windows

Assign a unique IP address to the AXIS product using a computer on your network as follows:
1. Acquire an unused IP address for the AXIS 292 from the network administrator. The
AXIS 292 must be installed on the same subnet as the computer.
2. Connect a standard network cable from the AXIS 292 to the network.
3. Locate the serial number/MAC Address (S/N) on the label on the underside of the AXIS
292.
4. From a computer on the network, open a Command Prompt, i.e. from the Windows Start
menu, select Run... and type command or cmd in the field. Click OK.
5. Enter the commands:
Syntax:
arp -s <IP address> <MAC address>
ping -l 408 -t <IP address>
Note: The ping command is
followed by -l (lower case L)
Example
6. Connect power to the AXIS 292.
7. When 'Reply from 192.168.0.125: ...' is displayed (approximately 10-15 seconds), type
Ctrl+C to close the ARP Ping session.
Start a Web browser, enter the IP address in the Address/Location field and Press Enter.
8.
Enter a password for the root user (administrator). See Setting the password, on page 6.
9.
10. The installation is now complete. Proceed to Accessing the AXIS 292, on page 10.
Note:
If the password is lost, the AXIS 292 must be reset to the default settings. Refer to Factory
default settings, on page 11, for instructions.
AXIS 292 Installation Guide