LG DLEX7700 E Manual De Usuario página 52

52
TROUBLESHOOTING
Before Calling For Service (cont.)
Clothes take
too long to dry
properly.
duct run is too long.
breaker has tripped, or power
outage has occurred.
Clothes are
wrinkled (overdried).
after cycle ends.
Clothes are
shrinking not being followed.
Water drips
from nozzle
when Steam
Cycle starts
Steam does not
generate but
no error
code is shown
Garments still
wrinkled after of garments in dryer.
Steam Fresh™
heavier items take longer to dry.
retain more moisture. To help reduce and maintain more
consistent drying times for large and heavy fabrics,
separate these items into smaller loads of a consistent
size.
you are drying.
some loads that produce high amounts of lint, it may be
necessary to clean the filter during the cycle.
and free of debris, lint, and obstructions. Make sure that
outside wall dampers can open properly and are not
blocked, jammed, or damaged.
fuse capacity. If the problem is a circuit overload, have it
corrected by a qualified electrician.
to ensure proper tumbling action.
Try a shorter drying time, and remove items while they
still retain a slight amount of moisture.
of the cycle. Use the Wrinkle Care option to continue
care instructions for your garment, because some fabrics
will naturally shrink when washed. Other fabrics can be
washed but will shrink when dried in a dryer. Use a low or
no heat setting.
after a short time.