The Auto Operating Mode - Kübler CODIX 533 Operación Manual

4.2.3 The Auto Operating Mode

1. The following parameters can be programmed for
the Auto mode:
1 sec
8
A
see 4.2.3.1
to
to
to
to
to
to
2. Functions
– SPecial display function, see 4.2.3.1
– SiGnal allows selecting the setpoint
output in volts or mA.
– time allows selecting the time unit in
seconds or minutes.
– Number of PEriods allows defining the
number of reference points.
– output 1 allows selecting the current
or voltage value for the first reference point.
– PEriod. 1 allows defining the duration
of the first period.
(A maximum of 20 periods may be programmed)
The maximum setpoints ou. X and the times PE. X
result from the setting of PEr.
– The function cYcle allows defining the
number of cycles to be carried out.
If cYcle = 0,
is displayed automatically after 1 sec-
ond. noCYcle will start an endless loop.
Press both keys simultaneously to switch over to the
following parameter. Within a parameter, select the
decade with the left key and select a value from
0 ... 9 with the right key.
3. After setting the value of cYcl, press both keys
simultaneously; the following message is dis-
played:
4. Use the right key to select YES or no
⇑
5. If YES is selected, press both keys simultaneously
to end the programming
⇑ ⇑