Intended Purpose; Start-Up; Reset, Back To Factory Setting; Programming And Operation Of The Setpoint Generator With The 2 Keys - Kübler CODIX 533 Operación Manual

2.1 Intended Purpose

This device shall only be operated as a built-in
device. Its fields of application are industrial process-
es and controls for manufacturing lines in the metal,
wood, plastic, paper, glass and textile industry, and
similar applications.
Overvoltages at the screw terminals of the device
must be limited at the values of the overvoltage cate-
gory II.
If the device is used for monitoring machines or
process flows, in which a breakdown of the device or
an operating mistake might lead to machine dam-
ages or operator accidents, the user must take suit-
able safety measures.

3. Start-up

After powering the device, the following message is
displayed for 2 seconds:
Then the device type is displayed for 2 seconds, fol-
lowed by the software version, also for 2 seconds.
After reading the EEPROM, the device switches to
the operating mode.

3.1. Reset, Back to Factory Setting

Press both keys simultaneously and power the
device: the following message appears on the display:
The device is reset to the factory settings and is now
ready for operation.
4
3.2. Programming and Operation of the Setpoint
Generator With the 2 Keys
⇑ ⇑
While programming, press both keys simultaneously
to switch over to the following parameter.
Within a parameter, confirm an input also by pressing
both keys.
⇑
The right key allows selecting the values of the para-
meters. To input a numerical value, select the decade
with the left key
⇑
and select a value between 0 ... 9
⇑
with the right key.