Recording from the Radio to a USB Flash Drive or Micro SD Card:
Insert the USB flash drive into the USB port or insert a micro SD card into the micro SD card slot.
Note: Only use either a USB flash drive or a micro SD card at a time, but not both when
recording. The unit may not record properly if both a USB and micro SD card are plugged in at the
same time.
1.
Set the Function switch to Radio.
2.
Set the Band switch to the desired frequency band (AM or FM).
3.
Adjust the Tune dial to select a radio station.
4.
Extend and adjust the antenna for best reception.
5.
To start recording, press and hold the side panel Rec./Rep. button.
6.
To stop recording, press Mode/Stop Rec button.
Recording Bluetooth to a USB Flash Drive or Micro SD Card:
1.
Insert the USB flash drive into the USB port or insert a micro SD card into the micro SD card
slot.
Note: Only use either a USB flash drive or a micro SD card at a time, but not both when
recording. The unit may not record properly if both a USB and micro SD card are plugged in at
the same time.
2.
Set the Function switch to BT/USB/SD, and press the side panel Mode/Stop Rec button to
select Bluetooth Mode.
3.
Pair your Bluetooth device to the unit. See
4.
To start recording, press and hold the side panel Rec./Rep. button. The LED will slowly flash
red to indicate recording.
5.
Playback your Bluetooth source.
6.
To stop recording, press the side panel Mode/Stop Rec button. Press Mode/Stop Rec again to
playback the previously recorded track.
Playback
Playing a Tape:
1.
Press the Stop/Eject button to open the cassette holder.
2.
Insert a tape and close the cassette holder.
3.
Press the Play button to play the tape.
IMPORTANT! After extensive usage, tape heads can acquire oxide build-up, especially if the
cassettes are old. To ensure best performance, use a tape head cleaner periodically.
Pairing a Bluetooth Device
for pairing details.
9