Important - GE Profile 26 Manual Del Propieratio E Instalacion

I stall ti
I structi
efrigerator
Profile Model 26
Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: ge.com
In Canada, call 1.800.561.3344 or Visit our Website at: www.geappliances.ca
BEFORE YOU BEGIN
Read theseinstructions completely and carefully.
•
IMPORTANT
- Sovethese instructions
for locol
inspector's use.
• IMPORTANT -Observe oil g overning codes end
ordinonces.
• Note to Installer- Be sure to leovethese instructions with
the Consumer.
• Note to Consumer- Keepthese instructions for future
reference.
Skill level- Instollotion of this opplionce requiresbosic
mechonicol skills.
• Completion time- Refrigerotor Instollotion 20 minutes
Woter Line Instollotion 30 minutes
Proper instollotion is the responsibilitUof the instoller.
Product foilure due to improper instollotion is not covered
under the Worront U.
PREPARATION
MOVING THE REFRIGERATOR INDOORS
If the refrigerator will not fit through a doorwag,
the refrigerator door and freezer drawer can be removed.
• To remove the refrigerotor door,see the Installing
the Refrigeratorsection.
• To remove the freezer drower, see the Removing
the FreezerDrawer section.
WATER SUPPLY TO THE ICEMAKER AND DISPENSER
If the refrigerotor hos on icemoker, it will hove to be
connected to o cold woter line.A GEwoter supplUkit
(contoining tubing, shutoff volve, fittings end instructions)
is ovoiloble ot extro cost from uour deoler,bUvisiting our
Website ot ge.corn (in Conodo ot www.geappliances.ca)
or from Ports end Accessories,800.626.2002(InConodo
1.888.261.3055).
TOOLS YOU MAY NEED
10mm SocketRatchet/Driver
AdjustableWrench
1/4" OuterDiameter
Compression N ut
andFerrule(sleeve)
Phillips-Head Screwdriver
3/32", 1/8" and4 mm
Allen Wrenches
1/8" Drill Bit and
Electricor HandDrill
Pencil
Pliers
Flat-Head Screwdriver
TapeMeasure
1/4" Nut Driver
Level
24