Connection To Dust Collection System; Assembling The Machine - HOLZMANN MASCHINEN TFM610V Instrucciones De Servicio

14.2.3

Connection to dust collection system

The dust collection system must start at the same time as the motor of the machine.
In addition, the dust collection system must guarantee an output of at least 800
m3/h.

14.3 Assembling the machine

The machine is pre-assembled, the parts removed for transport must be assembled according to
the following instructions and the connection to mains have to be made.
Assembly milling stop
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
NOTE
1. Assembly support rods (x2) for
downholder.
 insert the support rod into the
holder of the milling stop (C; D) and
fasten with the screw (S) using an
Allen key (B).
2. Assembly milling stop
 Insert part B into the grooves
provided and fix it with screw S1.
Insert the two screws S2 and
insert the 4 screws S3 to fix the
stops.
3. Mounting milling stop onto
machine
 Die Insert the two screws (S) of
the assembled milling stop into the
slots (B) on the machine table and
fix them. Then insert the slots of
the milling stops (C) into the two
screws (S1) and fix them with a
knob.
ASSEMBLY
26
TFM610V