Setting The Workpiece Support; Connection To A Dust Collection System; Switch Machine On-Off; Switch Laser On-Off - HOLZMANN MASCHINEN KAP305JL Manual De Usuario

16.2.6 Setting the workpiece support

16.2.7 Connection to a dust collection system

For dust extraction in closed rooms, connect a suction hose to the dust extraction nozzle and fix it
with a hose clamp. Connection dimensions according to technical data.

16.2.8 Switch machine ON-OFF

16.2.9 Switch Laser ON-OFF

HOLZMANN MASCHINEN GmbH
in the screw for a deeper cutting position, screw out the
screw for a higher cutting position and then fix it again by
tightening the nut (1a).
The lowest cutting depth limit must be selected so that the
saw blade only dips approx. 5 mm into the table insert.
The workpiece supports on the right and left sides can be
adjusted in their position in relation to the table.
Positioning in direction A:
To do this, loosen the screw (3), pull out the workpiece
support rod (3) or move it to the turntable and then fix it
in the required position by tightening the screw (3).
Positioning in direction B:
To do this, loosen the two screws (2), move the
workpiece support bar (4) up or down to the desired
height position and then fix it in the selected position by
tightening the two screws (3).
The workpiece support can be used as a support for
longer workpieces as well as a stop.
Switch the machine ON:
Press the locking button (1) and then press and hold down
the ON/OFF button (2) on the handle. Light (3) indicates the
start.
Switch the machine OFF:
Release the ON-OFF switch (2)
Switch the laser on/off with switch (1).
Switch in position 0: Laser switched off
switch in position 1: laser switched on
www.holzmann-maschinen.at
N O T I C E
Check the setting by performing a test cut.
OPERATION
41
KAP305JL