Disconnec Ng Remote Controls; Replacing Ba Eries; Rese Ng The X1 Siren To Factory Se Ngs; Window & Door Sensors - Tiiwee X1 Manual De Usario

Disconnec ng remote controls

IMPORTANT: With this procedure, all remote controls are disconnected.
Please make sure to reconnect the remote controls you wish to
con nue to use with the X1 siren.
o
Deac vate the X1 siren by pressing the Deac va on bu on on the X1 siren
or the remote control.
Press the SET bu on for 5 seconds. You will hear a beep and all four LEDs
■
light up.
Press the SET again for 5 seconds. You will hear four beeps and all the
■
LEDs will quickly blink four mes.
Short press the On/Off bu on.
■
All remote controls are now disconnected from the X1 Siren. To reconnect a
remote control, please consult the chapter "Expanding your
system – connec ng remote controls".
Low ba ery indicators
Replace all ba eries when this happens:
X1 Siren: You will hear 3 beeps every 20 seconds.
Door sensors: The red LED of the sensor are blinking or con nuously lit.
PIR mo on sensors: The indicator light in the front is lit con nuously.
When the indicator light has been switched off manually, the low
ba ery indica on will not be shown.

Replacing ba eries

Remote control: Remove the screw on the back of the remote control. Open
the remote control and remove the second screw on the electronic board. This
will give you access to the other side of the electronic board, where the ba ery
is located. The ba ery type is CR2032 (3V, Lithium ba ery).
X1 Alarm unit: Slide off the back panel and replace the ba eries with 3x AA
size 1.5V alkaline ba eries. Do not use rechargeable ba eries.
10
Door sensors:
Place a screwdriver or knife in the opening at the bo om and use it as a
■
lever to gently li the case from the back plate.
Take out the old ba ery and replace it with a fresh 12V/23A alkaline
■
ba ery - please note the correct polarity.
Put the ba ery cover back in place and push it un l you hear a click.
■
PIR Mo on detectors: Slide off the back plate and replace the ba eries with
2 x AAA or 3x AAA ba eries depending on the model you use.

Rese ng the X1 siren to factory se ngs

This procedure will erase all informa on from the X1 siren which is related to
sensors and remote controls.
Take out one ba ery from the X1.
■
While keeping the SET bu on pressed, re-insert the ba ery.
■
A er a few seconds, you will hear 10 beeps with longer intervals
■
followed by another 10 beeps with shorter intervals.
Now, release the SET bu on.
■
Now, the X1 restarts automa cally.
■
Your X1 Siren is now reset to factory se ngs. You can reconnect your remote
controls and sensors.
Window & door sensors
IMPORTANT: Please assure that the distance between magnet and sensor does
not exceed 8 mm.
Product Overview and Opera on
The door sensor consists of a magnet and a sensor which contains a detector
for changes in magne c fields ('flux'). When the magnet is moved away from
the sensor, the sensor will detect that mo on and will send a wireless signal to
the Tiiwee Alarm unit. The Tiiwee Alarm unit will now emit a powerful alarm
sound or a doorbell-sound depending on the se ngs of the Alarm unit.
11