Juiceman JM300 Manual De Instrucciones página 5

Tip: Try alternating types of produce being juiced to ensure maximum
efficiency.
9. Once you have finished juicing, turn control switch to OFF (0). Be sure
to unplug juicer from the outlet, when not in use.
Tips for optimum juicing
To avoid excessive pulp
buildup on the inside of the lid...
If excessive noise or vibrations
occur once juicer is turned on...
To manage the amount of spray as Juice produce as slowly as
juice pours out the juice spout...
7
Try juicing slower, as wet produce
is more likely to build up on the
lid. To release pulp, lightly tap on
side of lid. Always empty pulp
basket when it becomes full. This
will also help prevent pulp from
leaking into juice.
Pulp may have built up on filter
basket. Clean filter basket and try
alternating different types of
produce while juicing.
Note: Due to its powerful motor,
a small amount of noise and/or
vibration is normal when juicer is
turned on, and as it comes to a
complete stop. All juicers will
sound slightly different.
possible to avoid excess pulp
buildup inside the lid and juice
bowl. Keep pulp basket emptied
for good air flow through the
machine.
Assembly Instructions
(For your reference, please refer to the assembly illustration on page 4.)
Important: Always make sure juicer is unplugged before starting
to assemble.
Step 1: Place juice bowl
Position the juice bowl over the motor base with the juice spout to
the right. Lower juice bowl onto motor base so that juice spout slides
through the oval ring on the motor base.
Step 2: Place filter basket
With both hands, grasp rim of filter basket and center it over motor base
hub inside the juice bowl. Carefully lower filter basket onto hub, rotating
slightly until it drops into place; press firmly down on rim of filter basket
to secure (be sure to apply equal pressure to both sides of filter basket,
to ensure proper seating). When seated properly, filter basket will spin
freely and will not lift out of the juice bowl.
Step 3: Place lid
Place lid on juice bowl so that the pulp ejection opening is positioned
over the pulp spout.
Step 4: Attach feed tube
Center feed tube over lid opening so that the safety lock hook on the feed
tube is slightly right of the arrow on the lid. Insert the three tabs located
around bottom of the feed tube into three corresponding slots in the lid
opening. Rotate feed tube counterclockwise until safety lock tab on feed
tube aligns with the arrow on lid.
Step 5: Secure lid locking lever
While pressing down on safety lock button, swing lid locking lever
upward until safety lock hook on the feed tube is engaged. Once the lid
locking lever is fastened in place, release the safety lock button.
Important: Juicer will not operate if the lid locking lever is not
properly attached.
Step 6: Position pulp basket
Slightly tilt pulp basket and place it directly beneath the pulp ejection
opening. Push the bottom of pulp basket inward so top edge slides up,
behind the pulp spout. Continue to press firmly on the bottom of the
pulp basket until it fits snugly against the motor base. When correctly
positioned, pulp basket will be completely covered by the lid.
Important: Juicer will not operate if the pulp basket is not properly
placed against the motor base.
8