CARLO GAVAZZI SHOWEAGPS Datos Técnicos E Instrucciones De Instalación página 12

EN
To remove it, the weather station can be simply pulled upwards out of the mount,
against the resistance of the fastening.
2.3. Notes on mounting and commissioning
Do not open weather station if water (rain) might ingress: even some drops might
damage the electronic system.
Observe the correct connections. Incorrect connections may destroy the weather sta-
tion or connected electronic devices.
Please take care not to damage the temperature sensor (small blank at the bottom part
of the housing.) when mounting the weather station. Please also take care not to break
away or bend the cable connection between the blank and the rain sensor when con-
necting the weather station.
Remove all existing protection labels after installation.
The correct wind value may only be supplied approximately 60 seconds after the sup-
ply voltage has been connected.
SHOWEAGPS Weather Station • Version: 28.10.2013 • Technical changes reserved. Errors reserved.
12
Fig. 10
Make sure the cover and bottom part are
properly snapped together! This picture is
looking at the closed sensor from under-
neath.
Fastening
Fig. 11
Push the housing from above into the fas-
tened mount. The bumps on the mount must
snap into the rails in the housing.
Installation and commissioning