Preparing The Sensor - CARLO GAVAZZI SHOWEAGPS Datos Técnicos E Instrucciones De Instalación

EN

2.2.3. Preparing the sensor

Unsnap cover and
remove upwards
Fig. 7
1) Cover Snaps
2 Bottom part of housing
The weather station cover with the rain sensor snaps in on the left and right along the
bottom edge (see figure). Remove the weather station cover. Proceed carefully, so as
not to pull off the wire connecting the PCB in the bottom part with the rain sensor
in the cover (wire with push-connector).
Push the connecting cable through the rubber seal on the bottom of the weather sta-
tion and connect the power and bus cables to the terminals provided for this purpose.
The connection is by typical telephone cable (J-Y(ST)Y 2 × 2 × 0.8).
The connection cable must be plugged in between the cover and circuit board.
SHOWEAGPS Weather Station • Version: 28.10.2013 • Technical changes reserved. Errors reserved.
9 Installation and commissioning
1
2