Coaxial Cable Testing; Continuity Testing - C-LOGIC 3400 Manual De Instrucciones

Example: Wire pair 1-2 and pair 3-6 are short circuit.
In debug mode indicators will show as follow:
• Wire pair 1-2 flashes green light, wire pair 3-6
indicator and short circuit indicator flashes red light.
• Wire pair 3-6 flashes green light, wire pair 1-2
indicator and short circuit indicator flashes red light.
• 4-5 indicator shows green lights (no error)
• 7-8 indicator shows green lights (no error)

2.2 Coaxial Cable Testing

&
WARNING
TO AVOID ELECTRICAL SHOCKAND INJURY,
UNPOWER THE CIRCUIT WHILE PERFORMING
TESTS.
Follow the steps:
a) Connect one end of coaxial cable to transmitter
BNC socket, another end to remate BNC socket.
b)Power on the Tester, power indicator is on.
c) BNC indicator should be off. lf the light is on, the
network is miswired.
d) Press "BNC" button on the transmitter, if coaxial
cable indicator display green light, the network
connection in good condition, if the indicator
display red light, the network is miswired.
11

2.3 Continuity Testing

&
WARNING
TO AVOID ELECTRICAL SHOCK AND INJURY,
UNPOWER THE CIRCUIT WHILE PERFORMING
TESTS.
a) Use function "CONT" on the transmitter to do the
testing (to test both ends of cable simultaneously).
Turn the switch on the transmitter to "CONT"
position; connect red lead on the transmitter to one
end of the !argel cable and black lead to the other
end. lf the CONT indicator display red light, the
cable continuity is in good condition. (Network
resistance lower then 1 OKO)
b) Use "TONE" function on the transmitter along with
the receiver (when both ends of network cables are
not copresent.) Connect the wire adaptor on
transmitter to the network. Turn the switch to
"TONE" mode and the "TONE" indicator turns red.
Move the receiver antenna close the target network
cable, press and hold the power button on the
receiver. Adjust receiver vol u me through sensitivity
switch. Network is well connected if the receiver
makes buzz sound.
li!