Truper PUL-4X6T Instructivo página 19

Assembly
Working table for vertical sanding
• When the sanding bed is in a vertical position, you can
install the working table on it to make the sanding job
easier and more accurate.
• Remove the working table from its position to sand with
the disc.
• Remove the working piece support (B), to put in its place
the table support in the corresponding hole.
• Insert the knob through the table support slot and the
threaded hole below.
Adjust the working table
• The working table must be adjusted and calibrated
before starting the sanding job.
• Place the combination bracket on the table surface and
against the disc to make sure the table is at 0°.
• In case the table is not leveled loosen the adjusting knob
and tilt the table until it sets at 0°.
• Once the table is leveled, tighten the adjusting knob.
• Peel the auto adhesive graduated guide protection and
attach beside the dust extraction duct, make sure the 0
(zero) matches with the table support pointer.
Changing the sanding belt
• Turn off and unplug the sander.
• Lift the tension lever (2) to loosen the sanding belt rods and
lift the sanding bed to 45°.
• Remove the worn-out sanding belt.
• Place the new sanding belt passing both rods into the
belt.
• Make sure the direction arrow is pointing downwards, to
the driver rod.
• Center the belt in sanding bed.
• Move the tension lever to the left in order to tighten the
belt.
• Tighten the angle lock of the sanding bed (3).
• Connect and turn on for a moment the sander to look
thoroughly the belt performance. In case the belt moves
out from the sanding bed it should be adjusted.
• If the belt moves towards the disc, turn off the sander
and turn the aligning knob (4) 1/4 to the right. Turn on the
sander to verify and repeat the operation if necessary until
the belt is in its place.
• If the belt moves away from the disc, turn off the sander
and turn the aligning knob 1/4 to the left. Turn on the
sander in order to verify and repeat the operation if
necessary until the belt is in its place.
(E)
(F)
(G)
G
3
E
F
4
2
7
ENGLISH