Assembly - Truper PUL-4X6T Instructivo

• The sander must be fixed to a stable, solid, fixed, flat and
leveled working bench before starting up.
• Put the sander on the working bench, in the most
appropriate position to work. Consider at least a 12" space of
the sanding working table from any wall or obstacle, and in
case of working with large pieces, even more, to prevent
working pieces to bump and losing control of the tool.
• Mark with a pencil the four mounting holes on top of the
working bench.
• Remove the sander from the working bench and drill two
3/8" diameter holes on the marks.
• Fix the sander to the working bench with 5/16" diameter
screws, bolts and lock washers (not included). Gradually
tighten each screw one by one for perfectly sitting the
sander base.
Sanding disc and guard
• Peel off the disc protection from the auto adhesive
sander.
• Align the sanding disc with the aluminum disc and attach
pressing firmly.
• Put the disc guard on the bottom of the sanding disc, in
order to align the mounting holes and fix with two
pan-head screws included.
Working piece support
• Place the working piece support on the sanding band as
shown in the graphic and secure it with two sets of screws,
pressure bolts and bolts included. Do not tighten
excessively.
Working table
(C)
• Fix the support (1) to the working table by the three sets
of screws, pressure bolts and bolts included as shown in
the graphic. Do not tighten the screws.
Working table
(D)
• Place the table support on the corresponding hole on the
side of the graduated guide.
• Insert the knob through the working table support slot
and the threaded hole below.
• Loosen the screws fixing the working table to the support
to adjust, in order to stay perfectly parallel to the disc
surface and having a maximum 1/16" space between the
disc and the table. Tighten the screws.
• Insert the mitered guide bar in the working table slot.
6
ENGLISH
(A)
(B)

Assembly

1
D
A
B
C