Installing Modules - Desoutter CVI II Manual De Inicio Rápido

6159931440
Issue no: 01
Series: -

iNsTAlliNG MOdules

CVi ii range
● Check that the CVI controller firmware
version is 6.x as a minimum.
● Refer to the manual supplied in the kit.
CVix ii range
● Power off the controller.
● Locate the Fieldbus connector at the bottom
panel (see below).
legend
1 fieldbus connector
● Remove the cover
6 / 32
1
Carefully drive the module into its
location.
Slide it softly along the board located
below.
● Tighten the 2 screws by using a T8 Torx
screwdriver.
● Power on the controller.
CVi3 range
● Power off the controller.
● Locate the Fieldbus connector at the bottom
panel (see picture below). The cover is
protected by a grey cover.
legend
1 fieldbus connector
03/2012