ION Solar Stone Multi Guia De Inicio Rapido página 5

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 6
Connecting with Solar Stone Multi
Connecting to One Speaker/Establishing the Master Speaker
Note: Ensure the Master speaker is within range of your Bluetooth device in order to connect.
1.
Power on Solar Stone Multi by holding down the power button. You will hear "Power On" for
confirmation. *
2.
Ensure the speaker is in Bluetooth/Master mode. A blue LED will indicate the speaker is in
Bluetooth/Master mode. If a green LED appears, the speaker is not in Bluetooth/Master mode, it is in
Link mode. You will need to hold the Link button down for 2 seconds to exit Link mode.
Note: The speaker(s) power on in the last state it was in prior to last powering down the speaker.
3.
To connect a Bluetooth device for the first time, navigate to your device's Bluetooth setup screen, find
Solar Stone Multi, and connect. Bluetooth LED will light up solid when it is connected and you will
hear "Connected" for confirmation. *
Note: The speaker will automatically connect to a previously paired Bluetooth device when powered
on in Bluetooth/Master mode.
Note: If you experience trouble in connecting, select "Forget this Device" on your Bluetooth device
and try to connect again.
Note: To disconnect from a paired Bluetooth device, press and hold the Bluetooth button on the
speaker. You will hear "Disconnected" for confirmation. *
* Tip: If you would like to disable (or enable) the voice prompts, simultaneously press the Bluetooth
Connect and Link buttons briefly.
Linking Additional Speakers to the "Master" Speaker with Multi-Link™
After establishing the "master" speaker by connecting via Bluetooth as described above, you can link an
unlimited amount of speakers to the "master" speaker to play the same music.
1.
Power on the additional speaker(s) you would like to link to the "master" speaker.
2.
Ensure the speaker(s) is in Link mode which will be indicated by the green LED. If a blue LED is seen,
press and hold the Link button to enable linking to the "master" speaker. The same audio playing from
the "master" speaker should now also be playing from the linked speaker.
* Tip: If you would like to disable (or enable) the voice prompts, simultaneously press the Bluetooth
Connect and Link buttons briefly.
Note: If you have multiple speakers, it is possible to use 1 speaker at a time.
5

Publicidad

Tabla de contenido
loading

Tabla de contenido