Samsung WA54M8750A Serie Manual De Usuario página 28

Installation
*
STEP 4 Leveling your washer
Level
28 English
WA8700M_WA54M8750A_DC68-03774B-02_EN.indd 28
A
A
Not Level
NOTE
Connect the hose guide (A) within 3-5 in
(7.6-12.7 cm)* from the end of the drain
hose. If the drain hose is extended beyond
the end of the hose guide, mold or
microorganisms could spread inside the
washer.
NOTE
The drain hose can be installed to a
maximum height of 96 in (245 cm), but the
draining capability can be reduced at this
height. It can cause the washer to have an
odor because of water remaining in the
drain system.
NOTE
If the drain hose is installed below 39 in (99
cm), water can be drained in cycles due to a
siphon phenomenon. It causes the washer to
display a "4C".
See if the washer is level by checking the
position of the tub:
1. Slide the washer into position.
2. Open the lid of the washer, and pour
water into the tub to just below the
pulsator level.
NOTE
WA54M8750A* models have a built-in sink
over the pulsator level. Open a built-in sink
and check the level visually.
2017-04-18 9:59:47