EGO PSA1000 Manual Del Usuario página 15

Accesorio para la sierra de pértiga
Ocultar thumbs Ver también para PSA1000:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CONNECTING THE EXTENSION POLE EP7500 BETWEEN THE POWER
HEAD AND THE POLE SAW ATTACHMENT (Available Separately)
WARNING:
running or with the battery installed. Failure to stop the motor and remove the battery
may cause serious personal injury.
This extension pole is designed for exclusive use with EGO Power Head PH1400 and
Pole Saw Attachment PSA1000. Never use it with other EGO attachments.
The extension pole extends the cutting range. It should to be connected between the
pole saw attachment and the power head.
Follow the process in the section
"CONNECTING THE POLE SAW
ATTACHMENT TO THE POWER HEAD" to
install the extension pole between the
pole saw attachment and power head
(Fig. 3).
NOTICE:
Once assembled correctly, the
pole saw attachment, extension pole and
the power head should not separate when
pulled. Always test the connection by
pulling on them. Repeat the steps above if the pieces can be separated.
WARNING:
instructed above could result in serious injury or death.
REMOVING THE ATTACHMENT FROM THE POWER HEAD
1. Stop the motor and remove the battery pack.
2. Loosen the wing knob.
3. Press the shaft-release button and, with the button depressed, pull or twist the
pole-saw shaft out of the coupler to separate it from the power head or the
extension pole (if used).
4. Repeat the process to separate the extension pole from the power head
(if extension pole is used).
Never attach or adjust any attachment while the power head is
Failure to secure the attachment and power head/extension pole as
3
Coupler on the Extension Pole
Extension Pole
POLE SAW ATTACHMENT — PSA1000
Coupler on the Power Head
15

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido