STEINEL TR 100-M Manual Del Usario página 8

14
Operation
Low voltage inputs
Blue - (Control input) for
use with an occupancy
sensor, photo control or
other signalling device
providing a maintained
(12 to 24 VDC) voltage
return signaling the
power pack. If using the
TR 100-A or TR 150-A,
the power pack relay
will close and turn on
the load. If using the
TR 100-M or TR 150-M
manual on power pack,
the occupant must first
press the momentary
switch before the relay
will close and the load
will turn on. When voltage
is removed from the
www.steinel.net
(800) 852-4343
blue input wire the relay
will open and the load
will be turned off. If the
momentary switch is
pressed while no voltage
is on the blue wire the
load will turn on for 30
seconds and then back
off.
Orange (Override On) -
intended for use with
maintained (12 to 24 VDC)
voltage return from a
time clock, building
management system or
override switch. When
voltage is applied to this
input, the relay will close
and turn the load on.
If the momentary switch
is pressed while voltage
Operation
is on the orange wire, the
relay will open and the
load will turn off. When
voltage is removed from
the orange (override on)
input, the load will turn
off if there is no signal on
the blue (control) sensor
input.
Brown (force off) -
intended for use with a
building management
system, photo controller,
demand load control
or override off switch
providing a maintained
voltage input of (12 to
24 VDC). When voltage
is applied to the brown
(force off) input, the
power pack relay will
www.steinel.net
15
open turning the load
off irregardless of
occupancy (blue wire)
or force on (orange wire)
inputs. If the momentary
switch is pressed while
there is voltage to the
brown (force off) input,
the load will turn on for
30 seconds and then
back off. The force off
input overrides all other
inputs to the power pack.
(800) 852-4343