Epson LABELWORKS LW-600P Guía De Referencia Rápida página 66

This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of
the following measures:
■ Reorient or relocate the receiving antenna.
■ Increase the separation between the equipment
and receiver.
■ Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
■ Consult the dealer or an experienced radio/TV
technician for help.
An AC adaptor with a ferrite core must be used for RF
interference suppression.
Warning: The connection of a non-shielded
equipment interface cable to this equipment will
invalidate the FCC Certification or Declaration of
this device and may cause interference levels which
exceed the limits established by the FCC for this
equipment. It is the responsibility of the user to
obtain and use a shielded equipment interface cable
with this device. If this equipment has more than
one interface connector, do not leave cables
connected to unused interfaces. Changes or
modifications not expressly approved by the party
responsible for compliance could void the user's
authority to operate this equipment.
This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment. This
equipment should be installed and operated with
minimum distance 7.8 inches (20 cm) between the
radiator and your body.
Avisos | 65