Star Progetti Blueapp Box STAR7 Instrucciones De Uso página 12

CAUTION: FIRE HAZARD
• Do not modify the product in any way.
• Do not place objects on the power regulator.
• Do not cover or obstruct the power regulator while it is running.
• Visually inspect the product on a regular basis to check for damage. In
case of defects, do not use the power regulator and contact an
authorized T echnical Service Centre immediately.
• Make sure that the electrical system to which the product is connected
is up to code.
• The STAR7 power regulator must be properly connected to an efficient
earthing system as required by current electrical safety regulations. In
case of doubt, contact a qualified electrician to check it thoroughly.
• Connect the product to the mains only if the capacity of the
system is able to handle the maximum power rating. If not, please
contact a qualified electrician immediately.
• If the product drops or is subject to a heavy blow, bring it
immediately to an authorised Technical Support Centre so it can be
checked.
• In case of malfunctioning and/or failure, disconnect the device from
the mains. Contact a Star Progetti Service Centre immediately.
• Do not use the power regulator for energy-saving fluorescent lamps.
• Do not use the power regulator for adjusting electric motors or
transformers.
• Using the product for any purposes other than those specified in this
instruction booklet may cause damage to STAR7, as well as short
circuits and fire.
• The mains voltage must match the information on the name plate
affixed to the STAR7 power regulator.
• All applicable accident and safety regulations in the country of
installation must be complied with.
• The heat sink on the housing with a maximum load of 4400 watt may
reach a temperature of
60°C.
• The power regulator must always be connected to the earth contact.
• Check the power regulator on a regular basis to verify whether there
are any malfunctions.
12