Remote Control Operation - Star Progetti Blueapp Box STAR7 Instrucciones De Uso

REMOTE CONTROL OPERATION

The supplied remote control performs the function of:
❑ "ON / OFF" switching on and off
❑ "POWER +", "POWER -" power adjustment for a total of 5 power levels.
Always point the remote at the sensor on the unit.
1. POWER:
Press the "ON / OFF" button for 1 or 2 seconds. The green light (which confirms the electric
start) will light up immediately and after about 2 seconds the appliance will reach the power
level corresponding to the minimum level.
2. POWER adjustment:
By repeatedly pressing the "POWER +" button you can set up to 5 different power levels. The
controller LED changes color according to the scale shown below.
3. OFF:
Press the "ON / OFF" button for 1 or 2 seconds.
MAINTENANCE
The STAR7 power regulator does not require any maintenance. However, it does need to be
cleaned on occasion using a dry anti-static cloth. Caution: Make sure to disconnect STAR7
from the mains before performing any cleaning tasks. Do not clean using sharp instruments.
TECHNICAL DATA
▪ 220-240V power supply 50/60 Hz Frequency
▪ Maximum load 4400 Watt (resistive loads only)
▪ Room temperature -20°/+30° Protection rating IP56
▪ Soft start -
▪ Dimensions : 120 x 190 x 60 mm
The LED changes color
(Green, Yellow, Orange,Magenta, Red)
according to the set power level.
MIN - 2 - MED - 4 - MAX
THE START OF THE HEATER STARTS IN 2 SECONDS FROM
THE IGNITION OF THE GREEN INDICATOR ON THE
REGULATOR. DO NOT EXCEED WITH THE PRESSURE ON
THE BUTTONS OF THE REMOTE CONTROL TO AVOID THE
EXHAUST OF THE BATTERY. WHEN THE FAILURE OF THE
GREEN INDICATOR HAS FAILED, THIS COULD BE CAUSED
BY THE LOW BATTERY LEVEL OF REMOTE CONTROL.
16
CAUTION