Star Progetti STAR6 Instrucciones De Uso página 11

CAUTION: ELECTRIC SHOCK HAZARD
•
STAR6 must be installed by professionally skilled staff.
•
Do not use the power regulator near bathtubs, showers or swimming pools. Install it in
compliance with all legal requirements concerning appliances with a water protection rating of
IP56.
STAR 6 HEA T power regulator OPERA TING INSTRUCTIONS (cod. STAR6)
Thank you for purchasing the STAR6 heat power regulator. STAR6 is a high-quality product that is
built to last. All Helios IRK heaters can be equipped with STAR heat power regulators. Our heat
power regulators ensure maximum flexibility in heat control and are constructed using the latest
microprocessor technology.
All power regulators are checked before shipping to ensure their efficiency.
INSTALLA TION
The STAR6 power regulator must always be wall mounted on a non-flammable and stable surface
(e.g. tiles, cement, steel). The power regulator must be installed by attaching the housing in an
upright position with the heat sink at the top. The power and load cables must be of an
appropriate size and insulated. The earth conductor for the power supply and the load must be
longer than the others so that they are the last to tauten in case the cable clamp loosens. The power
regulator must not be installed inside containers or cabinets because a lack of ventilation can cause
damage. Use power and load cables that are able to withstand at least 90°. When installing, an
omnipolar circuit-breaker with a contact opening of at least 3.5 mm must be used.
The signal receiver may be disturbed when other electrical frequencies are transmitted from other
appliances operating in the same area that have the same frequencies.
STAR6 WIRING DIAGRAM
fig. 1
11