CONFIGURING MORE REMOTE CONTROLS - TWO OR MORE INDEPENDENT POWER REGULATORS
Attention:
Attention:
Never match two remote controls with the same POWER REGULATOR.
Never match two remote controls with the same POWER REGULATOR.
Deleting one remote control from the matching is not possible
Deleting one remote control from the matching is not possible
Matching more remote controls on the same power regulator is suggested when you need to
Matching more remote controls on the same power regulator is suggested when you need to
have more power regulators for the very same environment or in case of replacement
have more power regulators for the very same environment or in case of replacement
CONFIGURING 1 REMOTE CONTROL WITH 1 POWER REGULATOR
•
press button P1 on the card.
•
press the ON button within 2 seconds
•
press the OFF button within 2 seconds
CONFIGURING 1 REMOTE CONTROL FOR UP TO 3 POWER REGULATORS
POWER REGULATOR 1
Put the selector SW2 on the card of the first power regulator as per the drawing
•
press button P1 on the card
•
press the red ON button within 2 seconds
•
press the red OFF button within 2 seconds
B.If programming is unsuccessful, repeat the programming process.
POWER REGULATOR 2
Put the selector SW2 on the card of the first power regulator as per the drawing
•
press button P1 on the card
•
press the red ON button within 2 seconds
•
press the red OFF button within 2 seconds
B.If programming is unsuccessful, repeat the programming process.
POWER REGULATOR 1
POWER REGULATOR 2
13