Setup The Ups - Infosec E3 PERFORMANCE 5000VA Manual De Usuario

NOTE: When installing the UPS or battery pack with feet, please keep 70mm distance from
the edge of the unit.

2.4 Setup the UPS

Step 1 - UPS input connection

Plug the UPS into a two-pole, three-wire, grounded receptacle only. Avoid using
extension cords.
Model
E3
Performance
5000 RT
INPUT
Step 2 - UPS output connection

For socket-type outputs, there are an output terminal block for connection of the load via a
distribution board and two kinds of outputs: programmable outlets and general outlets.
Please connect non-critical devices to the programmable outlets and critical devices to the
general outlets. During power failure, you may extend the backup time to critical devices by
setting shorter backup time for non-critical devices.
INFOSEC UPS SYSTEM - 15, rue du Moulin - 44880 Sautron - FRANCE - www.infosec-ups.com
36
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)240 94 29 51 - hotline@infosec.fr – 12 18 AA 59 205 19
Wiring spec (AWG) mm²/AWG
Input
6mm²/AWG12
1.5mm²/AWG16 for
Terminal block wiring diagram
Output
6mm²/AWG12 for
terminal
10/16A Sockets
Wiring specs
Ground
6mm²/AWG12 for
terminal
1.5mm²/AWG16 for
10/16A Sockets
OUTPUT