Crown CT14019X Manual Original página 22

Symbol
Wear safety goggles�
Wear ear protectors�
Wear a dust mask�
Disconnect the power tool
from the mains before instal-
lation or adjustment�
Movement direction�
Rotation direction�
Locked�
Unlocked�
Attention� Important�
Prohibited�
Double insulation / protec-
tion class�
A sign certifying that the
product complies with es-
sential requirements of the
EU directives and harmo-
nized EU standards�
During operation, remove
the accumulated dust�
Caution! Possible injury from
sharp edges of a cutting ac-
cessory�
Do not dispose of the power
tool in a domestic waste
container�
Meaning
English
22
Power tool designation
The power planer is designed for planing, edge cutting,
grooving of wood and wood materials� The power
planer is designed for use by right-handers only�
There is a possibility of a stationary installation of the
tool by use of some special accessories�
Power tool components
1 Front base plate
2 V-groove
3 Planing depth setting scale
4 Additional handle with regulator for planing depth
adjustment
5 On / off sSwitch
6 Lock-off button
7 Protective casing
8 Safety stop
9 Back base plate
10 Ventilation slots
11 Nozzle
12 Side stop (assembly) *
13 Vertical stop *
14 Wing screw *
15 Wrench *
16 Blade sharpening device (assembly) *
17 Blade alignment fixture (assembly) *
18 Box wrench *
19 Bracket *
20 Thrust plate *
21 Fastening nut *
22 Clamping bolt *
23 Drum for interchangeable blades
24 Interchangeable blades *
25 Allen key *
26 Adjusting bolt
27 Fastening plate
28 Adjusting plate for interchangeable blade
29 Cover
30 Adjusting plate for resharpenable blade
31 Screw
32 Resharpenable blades *
33 Drum for resharpenable blades
34 Clamping bolt of blade sharpening device *
35 Template *
36 Plate *
37 Washer *
38 Winged nut *
39 Driving belt *
40 Housing screw
* Optional extra
Not all of the accessories illustrated or described
are included as standard delivery.
Installation and regulation of power tool
elements
Before carrying out any works on the power tool it
must be disconnected from the mains.
Do not draw up the fastening elements
too tight to avoid damaging the thread.