Eaton ADF142501 Manual Del Usuario página 4

Integrated Sensor Remote Programming
Set Energy Saver Scene
The Energy Saver Scene is used as a single scene
control that can be triggered from the handheld remote
or future mobile application. The Energy Saver Scene is
also used to save additional energy when the space is
vacant, by reducing the light level to the Energy Saver
Scene after 10 minutes of NO OCCUPANCY.
With lighting in the On position.
•
Point handheld remote at Integrated Sensor.
•
Adjust light level using On/Off, Raise/Lower
buttons to the desired Energy Saver Scene.
When light level has reached desired level
•
Press the "SET" button (LED blinks 3 times
•
rapidly)
Then press the "ES" button (LED links blinks
•
continuously for 5 seconds)
The desired light level is now stored as the Energy
•
Saver Scene
Set Daytime Unoccupied Light Level
With lighting in the On position.
•
Point handheld remote at Integrated Sensor.
•
Adjust light level using On/Off, Raise/Lower
buttons to the desired Daytime Unoccupied Light
Level.
When light level has reached desired level
•
Press the "SET" button (LED blinks 3 times
•
rapidly)
Then press the "DU" button (LED links blinks
•
continuously for 5 seconds)
The desired light level is now stored as the
•
Daytime Unoccupied Light Level
Set Twilight Occupied Light Level
With lighting in the On position.
•
Point handheld remote at Integrated Sensor.
•
Adjust light level using On/Off, Raise/Lower
buttons to the desired Twilight Occupied Light
Level.
When light level has reached desired level
•
Press the "SET" button (LED blinks 3 times
•
rapidly)
Then press the "TO" button (LED links blinks
•
continuously for 5 seconds)
The desired light level is now stored as the
•
Twilight Occupied Light Level
4
Set Twilight Unoccupied Light Level
With lighting in the On position.
•
Point handheld remote at Integrated Sensor. Adjust
•
light level using On/Off, Raise/Lower buttons to the
desired Twilight Unoccupied Light Level.
When light level has reached desired level
•
Press the "SET" button (LED blinks 3 times rapidly)
•
Then press the "TU" button (LED links blinks
•
continuously for 5 seconds)
The desired light level is now stored as the Twilight
•
Unoccupied Light Level
Set Nighttime Occupied Light Level
With lighting in the On position.
•
Point handheld remote at Integrated Sensor. Adjust
•
light level using On/Off, Raise/Lower buttons to the
desired Nighttime Occupied Light Level.
When light level has reached desired level.
•
Press the "SET" button (LED blinks 3 times rapidly)
•
Then press the "NO" button (LED blinks continuously
•
for 5 seconds.
The desired light level is now stored as the night time
•
occupied light level.
Set Nighttime Unoccupied Light Level
With lighting in the On position.
•
Point handheld remote at Integrated Sensor. Adjust
•
light level using On/Off, Raise/Lower buttons to the
desired Nighttime Unoccupied Light Level.
When light level has reached desired level
•
Press the "SET" button (LED blinks 3 times rapidly)
•
Then press the "NU" button (LED links blinks
•
continuously for 5 seconds)
The desired light level is now stored as the Nighttime
•
Unoccupied Light Level
Integrated Sensor Remote Programming
ADF142501 www.eaton.com