Koala Kare KB101 Instrucciones De Instalación Y Funcionamiento página 4

KB101
Step 4.
Find the stud where you will be attaching
the left side of the unit to the wall. Measure
up from the floor 59" (1499 mm), at the
center of the stud, and mark the wall. Mark
remaining holes using a measuring tape to
make sure the holes are precisely positioned.
Hold unit in place to verify. Use four ¼" x
3" (6 mm x 76 mm) panhead wood screws
with washers (supplied) when wall studs are
available.
If the wall surface is masonry or tile over
studs, use a 7/32" (6 mm) masonry drill
bit for the pilot hole until you hit the stud.
Change bit to 1/8" (3 mm) regular drill bit.
Use four ¼" x 3" (6 mm x 76 mm) panhead
wood screws with washers (supplied).
If the wall has wood studs that are not on
16" (406 mm) centers, has metal studs or an
underlying surface of concrete block, drill with
a ½" (13 mm) masonry bit. (You may have to
purchase toggles before installing.) You must
allow a minimum of inside wall space for
toggles to turn depending on toggles used. Insert and tighten toggles.
Step 5.
Position Koala sign (supplied) on the outside of the restroom door. Fill the built-in dispenser with
sanitary bed liners. Replacement parts and additional liners can be purchased from your local
distributor or by calling toll free 888.733.3456 or 303.539.8300 in the U.S.
KB111-SSWM
&
Installation Instructions
3