Advanced Bionics myPilot Manual Del Usuario página 17

To Activate the Auto Keypad Lock:
Press the center button.
1
Select Settings, Auto Keypad Lock and ON.
2
To Deactivate the Auto Keypad Lock:
Press the center button.
1
Select Settings, Auto Keypad Lock and OFF.
2
Reset Button
Important information
Maintenance and Care
Servicing or modification of the AB myPilot by any entity other than Advanced Bionics is not
•
permitted and will void the manufacturer's warranty.
• Clean the AB myPilot using a damp cloth. Never use household cleaning products (washing
powder, soap, etc.) or alcohol to clean the AB myPilot.
When the AB myPilot is not in use, turn it OFF and store it safely.
•
Protect the AB myPilot from excessive moisture (bathing, swimming) and heat (radiator,
•
car dashboard).
Protect the AB myPilot from excessive shock and vibration.
•
Safety Notice
Keep the AB myPilot out of reach of children under three years old.
Interference with Medical Devices
The AB myPilot uses low-power, digitally coded transmissions to communicate to the Naída CI.
30
AB myPilot User Guide
If, for some reason, the AB myPilot becomes
unresponsive, press the reset button on the
back as shown in the picture on the left.
No data will be lost.
Although unlikely, interference with medical devices such as pacemakers is possible.
Interference should not occur with normal use, keeping the AB myPilot 4" (10 cm) or more away
from the body. Therefore, it is recommended that pacemaker recipients do not keep the AB
myPilot in a shirt pocket.
Troubleshooting
Situation Most Probable Cause
AB myPilot turns
OFF automatically
AB myPilot may have encountered
AB myPilot becomes unresponsive
Brightness and/or contrast settings
Screen is white or dark
Status information displayed on AB Manipulations on the Naída CI
myPilot does not correspond with may not have been recognized by
current settings in the Naída CI
Question mark symbol is displayed AB myPilot may be out of range of
after performing the readout process
Naída CIs may be turned OFF
AB myPilot commands apply only to
one Naída CI as opposed to both
Naída CI PowerCel may be depleted
AB myPilot may be out of range of
AB myPilot commands are not
AB myPilot is too close or too far
received by the Naída CI(s)
away from Naída CI(s)
No Response Screen
Figure A
Remedy
Battery is depleted Charge AB myPilot
Reset AB myPilot
a software problem
Adjust the brightness and/or
might be sub-optimal contrast settings
Read out the status information as
described on page 18
AB myPilot
Move AB myPilot closer to Naída CI
Naída CI
Naída CIs must be turned ON to
correspond with AB myPilot. Turn
them ON by attaching PowerCel
to processor
Charge PowerCel or replace
Zn-Air batteries
Move AB myPilot closer to
Naída CI
unresponsive Naída CI
Hold AB myPilot >1/2" - 12" (1cm to
30 cm) from Naída CI and try again
Figure B
AB myPilot User Guide
31