Power Linking; Fuse Replacement - Chauvet DJ GigBAR Flex Guía De Referencia Rápida

AC Power
This product has an auto-ranging power supply that can work with an input voltage range of 100–240 VAC,
50/60 Hz.
To eliminate wear and improve its lifespan, during periods of disuse completely
disconnect the product from power via breaker or by unplugging it.

Power Linking

For the maximum number of GigBAR Flex that can be power linked at 120 V or at 230 V, see the User
Manual or the label on the product.

Fuse Replacement

1. Disconnect the product from power.
2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
3. Pry the safety cap out of the housing.
4. Remove the blown fuse from the clip on the front of the safety cap and replace with a fuse of the
exact same type and rating.
5. Re-insert the fuse holder and reconnect power.
IRC-6 (Infrared Remote Control)
The GigBAR Flex is fully compatible with the Infrared Remote Control (IRC-6) from CHAUVET DJ. For
more information on the IRC-6 or to download instructions, go to www.chauvetdj.com.
Mounting
Before mounting this product, read the
trussing (using appropriate clamps and with/without the included mounting brackets) or can be used floor/
surface mounted.
Mounting Diagram
IR Sensor
Bracket
Adjustment
Knob
GigBAR Flex QRG Rev. 1
QUICK REFERENCE GUIDE
Safety Notes. This product can be mounted to most tripods,
Microphone
Tripod (sold separately)
Insertion Point w/
Adjustment Knob for
Tightening
EN
Mounting
Clamp
(such as CLP-
15 from
Chauvet)
3