Craftsman 247.77013 Manual Del Operador página 14

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TopView
iiii_ FrontTab
i i
BagYC_hutei
/
Switch Wire
/
/
/
Figure11
Choke Control
Figure12
f
;/
Whenmovingthrottlecontrol lever,be carefulof heatedsurfacesand
sharpedgeson mufflerguard.
TO START ENGINE
1.
Attachspark plugwire and rubberbootto sparkplug.
2.
The bag/chuteswitch buttonmustbe fully depressedbythe tip
of front tab on bag handleor blowerchute for engineto start. See
Figure11.
3.
Makesurebag/chuteswitchwire is connectedto engineand
groundedto mountingbracket.See Figure11.
4.
Gas tank shouldbe filled3/4 to full beforestarting.
5.
Movethrottlecontrolto START/RUN (Rabbit)
position.See
Figure12.
_lf
6.
Movethechokecontrol
towardthe
throttle
control
to choke
the I",1 eng ne'scarburetor
(A warm
engine
may not requirechoking.)See Figure12.
7.
Standingbehindthe unit, graspstarterhandleand pull ropeout
until youfeel a drag.
8.
Pullthe rope with a rapid,continuous, f ull arm stroke.Keepa firm
grip on the starterhandle.Letthe roperewindslowly.
9.
Repeat,if necessary,untilengine starts.Whenengine starts,
move chokecontrolgraduallyawayfromthe throttlecontrol.
10. If enginefalters,movechoke controlback towardthe throttle
controland repeatsteps7 through9.
11. ALWAYS keepthe throttlecontrolin the START/RUN position
whenoperatingthe YardVacuum.
TO STOP ENGINE
1.
Movethrottlecontrolleverto slow(turtle) _
position.
Wheneverpossible,graduallyreduceengine speedbefore
stoppingengine.
2.
Movethrottlecontrolleverto STOP
or OFF position.
3.
Disconnectsparkplug wireand
groundit to prevent
accidentalstartingwhilethe equipmentis unattended.
TO EMPTY
BAG
1.
Unhookbag strapsfromthe lowerhandle.
2.
Unsnapbag clip from thetop of lowerhandle.See Figure13.
3.
Graspbag handlewith one hand and pull lock rod on mounting
bracketwith otherhandtowardengineto release.
4.
Lift bag off back of unit.
5.
Twistthe two buttonson the back of the bagto unlockand empty
contents.See Figure14.Holdbag handleand bag clip while
emptyingthe contents.
6.
Compressbagopeningand fold innerflap overopening.
7.
Foldouter flapoverinner flapand insertbuttonson the bag
throughmetaloutlets.See Figure14.
8.
Twistthe buttonsto lock bag.Placebag backonto unitas
instructedin the ASSEMBLY section.
Figure13

Publicidad

Tabla de contenido
loading

Tabla de contenido