General Safety Rules; Description; Assembling Information; Assembly Information - Rancilio MD 80 Instrucciones Originales

1. GENERAL SAFETY RULES

● The packing elements (plastic bags, expanded
polystyrene, nails, cardboard, etc.) must not be left
within the reach of children, as they are potential
sources or danger.
● Check that the data on the machine corresponds
to those of the electrical supply network, before
connecting the equipment.
● It is advisable to unwind the supply cable for the
whole length to avoid twisting or damages. Do not
place the cable near water, liquids or heat sources.
The cable must not be damaged.
● Should the cable be damaged, contact qualified
personnel to replace it by means of a special
tool.
● It is inadvisable to use adapters, multiple sockets
and/or extensions. When their use is indispensa-
ble, only products with certificate of quality (e.g.
IMQ, VDE, +S, etc.) may be used. Check that the
voltage capacity limit indicated on the adapters
exceeds the absorption capacity (A = ampere) of
the equipment.
● In doubt, request an accurate check of the plant
by qualified personnel. The wiring system must
comply with the following safety regulations:
- efficient earth connection;
- section of conductors suitable for absorption
capacity
- efficient ear th leakage protection circuit
breaker.
● Do not install the machine in the proximity heat
sources (oven, cooking stove, fireplace, etc.) and
in conditions in which the temperature may not go
below 5°C. IT MUST BE PROTECTED AGAINST
FREEZING CONDITIONS.
● Keep the packed machine in a dry place, not
exposed to atmospheric agents and in conditions
in which the temperature may not go below 5°C.
Do not stack more than three items of the same
kind. Do not place heavy items on the packa-
ging.
● In an emergency (fire, anomalous noisiness, ove-
rheating, etc.) disconnect the plug, turn off the gas
and water taps.
● Do not leave the machine exposed to atmospheric
agents (rain, sun, etc.) and do not install in damp
rooms such as bathrooms.
● In the event of parts replacement, request original
spares from an authorized retailer or dealer.
Erroneous installation may cause damage to
people and things for which the manufacturer
cannot be considered responsible.

2. DESCRIPTION

2.1. Assembly information

The machine is composed of a single structure for
coffee grinding and dosage.
The machine has a cast-aluminium base on which a
steel structure is mounted. The bean container with
self-contained grinder is placed in the upper part of
the machine, whereas in the front part the ground
coffee container with doser is positioned.

2.2. Functioning

The beans are collected in a hopper container fitted
with cover. After turning on the motor, the grinding
device under the container is activated. The ground
coffee is collected in the front container from where
the coffee doses may be taken by activating a hand
lever.
The possible adjustments are the following:
- grinding fineness
- delivered ground coffee dose.

2.3. Model configuration

MD40
Small size model with manual turn on/off modality.
MD50/ST
Medium size model with manual turn on/off moda-
lity.
MD50/AT
Automatic functioning medium size model with pos-
sible manual turn on/off modality.
MD80
Automatic functioning large size model with possible
manual turn on/off modality.
35