Powermate PWLE0799.1 Manual Del Usuario página 15

Maintenance
• Save all instructions
E
How to Replace the Belt (Continued)
4 . Remove the two Front Guard Screws and the Belt Guard .
(See Figure 12)
5 . Remove the old belt from the engine and quill
assembly pulleys .
6 . To install a replacement belt from the manufacturer,
reverse the steps above .
NOTE: The rear guard bolts should be tightened to 13-16
foot-pounds [18-22N-m] .
NOTE: The front guard screws should be tightened to 4-6
foot-pounds [6-8N-m] .
F
How to Change the Blade
WARNING
Do not sharpen the blade . Sharpening can damage the
blade and cause it to break, which can cause injury to you
or to others .
The blade is subject to nicks, scratches, and dents, which
will generally not affect function . The blade is also subject
to wear – reducing the cutting depth . Replace a worn blade
by following the steps below:
IMPORTANT: Only use a replacement blade from the
manufacturer. To order spare parts call us at 1-800-737-2112.
NOTE: Replacing the blade requires two (2) 12" adjustable
wrenches, or two (2) 3/4 in . [19mm] wrenches .
1 . Shut off engine .
2 . Disconnect the spark plug wire from the spark plug .
3 . Remove the blade locknut that holds the blade to the
drive shaft . (See Figure 13)
WARNING
To remove or tighten the blade locknut, always use the
method shown in Figure 13 . Always position the holding
wrench on the nut behind the blade .
4 . Remove the blade .
5 . Replace with new blade from the manufacturer by
reversing the above steps .
NOTE: Tighten the blade locknut to 35-45 foot-pounds
(47-61 N-m) .
Questions? Call Toll Free at 1-800-737-2112
(Continued)
Front Guard
Screws
Hold Nut,
Do Not Turn
Copyright © 2019 MAT Engine Technologies, LLC
EN - 15
Belt Guard
Front Guard
Screws
Figure 12
Turn counter-clockwise
to loosen
Turn clockwise
to tighten
Blade Locknut
Figure 13