Installation And Dismantling - auna MD-150-BT Manual Del Usaurio

SD/MMC slot (17): Tracks in relevant formats will be automatically played back once a SD/MMC card is inserted.
Reset button (18): To reset the system in case of system failure, press such button first and then reboot the system.
Numerical function buttons:
1/
When completed searching radio stations automatically, press this button to listen to available stations, press and
hold the same button to save such stations manually; In the MP3 mode, press this button to pause playback, and
press the same button again to resume.
2/INT
When completed searching radio stations automatically, press this button to listen to available stations, press and
hold the same button to save such stations manually; In the MP3 mode, press this button to browse tracks, and
press the same button again to quit.
3/RPT
When completed searching radio stations automatically, press this button to listen to available stations, press and
hold the same button to save such stations manually; In the MP3 mode, press this button to enable the function of
Single Repeat, and press the same button again to disable such function.
4/RDM
When completed searching radio stations automatically, press this button to listen to available stations, press and
hold the same button to save such stations manually; In the MP3 mode, press this button to enable the function
of Shuffle, and meanwhile, you can use buttons like and to select tracks randomly. Press the same button
again to disable such function.
5/-10
When completed searching radio stations automatically, press this button to listen to available stations, press and
hold the same button to save such stations manually; In the MP3 mode, press this button to play back the first 10
tracks.
6/+10
When completed searching radio stations automatically, press this button to listen to available stations, press
and hold the same button to save such stations manually; In the MP3 mode, press this button to play back tracks
more than 10.
Installation und Demontage
Installation Diagram
Before installing the main part, place it according to the installation locations and then connect with the corre-
sponding speakers and power-supply; Do not fix the main part unless it performs well.
Install the main part.
Place the holder on the dashboard and then bend certain snapping components by force; Connect with the power-
supply cable and speaker wires and then attach the fixing tag to the
automobile; Slide the main part into the holder and then tighten the
nuts on the fixing tag.
Dismantle the main part
Following loosening those nuts on the fixing tag, insert each disman-
tling key into the space on either left or right to pull the main part out.
Later on, detach the power-supply cable and speaker wires and then
the antenna connector.
14