Troubleshooting; Corrective Action - Kobalt KSB 5080-06 Manual Del Usuario

TROUBLESHOOTING

If you still have questions or an unresolved issue after going through this troubleshooting guide, or
just want to speak to a Kobalt product expert, please call our Kobalt customer service department at
1-888-356-2258.
PROBLEM
The handle is not
in position.
The snow thrower
doesn't start.
The motor is on, but
the impeller does
not turn.
The snow thrower
leaves a thin layer
of snow behind.
POSSIBLE CAUSE
1. The bolts are not properly
seated.
1. The battery is not charged.
2. The switch is defective.
3. Battery is too cold.
4. Battery is not fully seated in
the battery compartment.
5. Battery may require service
or replacement.
1. The belt is damaged.
1. The scraper is worn.

CORRECTIVE ACTION

1. Make sure the bolts are correctly installed
through the handle bars. Check to see if the
hand knobs are tight. Refer to Assembling
the Handles section in this manual.
1. Charge the battery by following the
procedures in the battery and charger
manual.
2. Have the switch replaced by an authorized
service center.
3. Remove battery from snow thrower. Bring
battery and charger into warm area for 15
minutes on charge. After 15 mins, remove
from charger and install in snow thrower for
use.
4. Remove battery, check compartment for
debris and foreign objects. Remove if
necessary and replace battery, ensuring
battery clicks into the battery compartment.
5. Call customer service at 1-888-356-2258 or
replace battery.
1. Replace the belt (see the section entitled
Replacing the Drive Belt).
1. Inspect the scraper for wear or damage. Re-
place the scraper (see the section entitled
Replacing the Scraper).
18