Crown CT26010HX Manual Original página 26

Symbol
III
Power tool designation
Power tool is designed for slot milling and treatment
of work piece brims made of wood based materials,
plastics, etc�
Power tool components
1 Cordless palm router
2 Ventilation slots
3 On / off switch
4 Stand-by mode on / off switch
5 Scale
6 Spindle lock
7 Collet clamp nut
8 Battery *
9 Battery lock *
10 Control button of the state of battery charge *
11 Indicators of the state of battery charge *
12 LED lamp
13 Speed selector thumbwheel
14 Base plate
15 Latch
16 Twist knob
17 Setscrew *
Meaning
Protection class�
Attention� Important�
A sign certifying that the
product complies with es-
sential requirements of the
EU directives and harmo-
nized EU standards�
Wear protective gloves�
During operation, remove
the accumulated dust�
Useful information�
Milling direction�
Do not dispose of the power
tool in a domestic waste
container�
18 Parallel guide (assembly) *
19 Guide with roller (assembly) *
20 Setscrew of dust extractor connecting adaptor *
21 Dust extractor connecting adaptor *
22 Collet (8 mm) *
23 Wrench *
24 Charger *
25 Collet (6 mm) *
26 Spindle
27 Fixing screw of roller holder *
28 Lead screw of roller holder *
29 Roller holder *
30 Roller *
31 Holder of parallel guide *
32 Screw of parallel guide *
33 Washer of parallel guide *
34 Guide *
35 Wing nut of parallel guide *
36 Indicator (green) *
37 Indicator (red) *
38 Charger label *
* Optional extra
Not all of the accessories illustrated or described
are included as standard delivery.
Installation and regulation of power tool
elements
Before carrying out any works on the power tool
remove the battery 8.
Do not draw up the fastening elements
too tight to avoid damaging the thread.
Installing / replacing accessories (see fig. 1)
After prolonged operation, the router bit
can become very hot, remove it using
gloves. This will also reduce the risk of
injury by the cutting edge.
• Before installing / replacing the router bit, it is
recommended (but not required) to remove the edge
trimmer 1 from the base plate 14, as described below�
• Turn the power tool upside down�
• Press the spindle lock 6 and after making sure that
spindle 26 is locked, keep spindle lock 6 in a pressed
position (see fig. 1.1).
• Release nut 7 using the wrench 23 (see fig. 1.2).
• Install / replace the router bit (or collet 22 or 25, if
required); keep in mind that the shank of the router
bit should be inserted into the collet 22 or 25 by at
least 20 mm (see fig. 1.3). The shank of the router bit
diameter should correspond to the inner diameter of
the collet 22 or 25�
• Tighten nut 7 using the wrench 23� Note: never
tighten nut 7 without the router bit - this can damage
collet 22 or 25�
• After all the operations have been completed, re-
lease spindle lock 6�
Installation of the power tool on the base plate (see
fig. 2)
• Open the latch 15, as shown in figure 2.1.
• Install the edge trimmer 1 on the base plate 14 (see
fig. 2.2). When installing the edge trimmer 1 on the
English
26