Read these instructions. Keep these instructions.
Heed all warnings. Follow all instructions.
WARNING
Connect the power plug to a grounded outlet or multi-tap. (Except for any
device without ground connection)
• A failure to do so may cause an electric shock due to a malfunction or
electrical short.
The Power Plug is the disconnecting device. In case of an emergency, the
Power Plug must remain readily accessible.
Do not look into the front of the lens when the projector is operating. Strong
light is projected from the product which can cause injury to your eyes.
If there is a gas leak from the gas lines, do not touch the outlet and be sure to
vent by opening the window.
• Sparks may be caused and lead to a fire or burns.
Do not touch near the vents during the operation or immediately after the
power is turned off as they generate intense heat.
• The heat does not indicate a defect or a problem of the projector when it is
operating so use it with confidence.
Keep the following precautions in mind to prevent the temperature rise inside
the projector:
– Install the air vents at least 30 cm away from the wall.
– Do not install the product in a place where it cannot be ventilated, such as on
a bookcase or in a closet.
– Do not install the product on carpet or cushion.
– Make sure that the air vents are not blocked with tablecloths, curtains, etc.
• It may cause a fire.
24