Perform Print Head Adjustment And Select The Connection Method - Canon imagePROGRAF TM-305 Guia De Instalacion

Perform Print Head Adjustment and Select the Connection Method

When the screen for selecting the
connection method appears, select
the connection method to use.
Wired LAN connection
This is the method for connecting the printer to the
network using a LAN cable.
1 Select Wired LAN connection.
Check the message about the connection
method and select Yes if there are no
problems.
2
A message prompting you to connect the
LAN cable appears.
3
Use the LAN cable to connect the wired LAN
connector on the side of the printer to the
hub port.
4
Select OK.
The paper starts feeding, and then the printer automatically starts charging the ink for the first time and adjusting the print head.
Charging the ink for the first time and adjusting the print head for the first time takes about 25 minutes.
• Do not open the covers of the printer or turn the power off while the ink is charging for the first time and the print head is being adjusted.
Important
• If you selected Do not connect, the connection settings and software installation will need to be performed separately.
Note
Proceed to "Connecting to the Printer" on p.12.
• Charging the system with ink fills the system from the ink tanks to the print head. In addition, cleaning is performed to keep the printer in optimal condition.
This may cause the remaining ink indicator and maintenance cartridge capacity indicator to drop some amount. Starter ink tanks are for first-time
installation. It is recommended that you purchase replacement ink tanks quickly.
Wired LAN connection
You can configure the printer and computer
connection settings and install the software while the
ink is charging for the first time and the print head is
adjusting.
Proceed to "Connecting to the Printer" on p.12.
Note
Wi-Fi connection
This is the method for connecting the printer to the
network without using a cable.
1
Select Wi-Fi connection.
Check the message about the connection
method and select Yes if there are no
problems.
2
A message prompting you to set up Wi-Fi
connection appears.
3 If you are configuring from a computer
-> Select Yes.
If you are configuring from the printer
-> Select No.
Wi-Fi connection
If you are configuring from a computer
-> You can configure the printer and computer
connection settings and install the software while
the ink is charging for the first time and the print
head is adjusting.
Proceed to "Connecting to the Printer" on p.12.
If you are configuring from the printer
-> Configure the Wi-Fi settings from the printer after
the printer has finished charging the ink for the first
time and adjusting the print head.
Proceed to "Configure Wi-Fi Settings on the Printer" on
p.13.
11
• If you are connecting the printer to the network using a fixed IP
address, select Do not connect. Configure the settings from the
touch screen of the printer after the printer has finished charging
the ink for the first time and adjusting the print head.
This is the method for connecting the
printer to a computer using a USB cable.
Do not connect the USB cable yet.
1
Select USB connection.
Check the message about the
connection method and select Yes
if there are no problems.
You can configure the printer and computer
connection settings and install the software
while the ink is charging for the first time
and the print head is adjusting.
Proceed to "Connecting to the Printer" on
p.12.
USB connection
USB connection