Installation; General Information; Mo Unting Cover And Assembled Rail Sections - Jung Pumpen SGR 125 Manual De Instalación Y Del Operario

Safety • Installation
Description
thank you for purchasing this Jung pumpen product. to
help ensure years of trouble-free operation, please read
this manual carefully.
Jung pumpen corrosion resistant rail lift systems are
used in residential, commercial, and industrial sewage,
effluent drainage and seepage water pumping systems.
the basic system includes all required rails, quick
disconnect fittings, supports, and hardware. additional
rail segments and intermediate bracing are available to
lengthen the rail system.
These installation instructions are not intended to
preclude normal safety procedures, which should be
followed to prevent injury to personnel . Safe installation
procedures shall be entirely the responsibility of
the installer .
In addition to proper system engineering and competent
manufacturing, the use of rail system installers who have
both practical experience and integrity to insist that the
equipment be installed properly constitutes the greatest
protection from component failure and liability exposure.
stainless steel rail lift systems normally give many
years of trouble-free service when correctly installed,
maintained, and used. However, unusual circumstances
(freezing, blockage, etc) may prevent your system from
functioning normally. to prevent possible damage,
consult your dealer about installing alarm or other
warning devices.
see Troubleshooting in this manual for information about
common rail system problems and remedies. For more
information, see your retailer, call Jung pumpen customer
service at 1-800-642-5930, or visit our web site at
jungpumpen-us.com.

Installation

General Information

these instructions apply to lift systems designed for
pumps with 1-1/4" npt or 2" npt discharge and 4"
horizontal discharge flanged pumps, up to 7-1/2 Hp and
up to 300 lb. in weight.
Flow Components: the movable disconnect is made of
brass or cast iron. the ball check valve is made of cast
iron or PVC. The gate valve is made of brass or PVC.
Rail Components: the rails, brackets, guide plates and
arms, couplers, and hardware are made of stainless steel.
Lift-Out Chain / Cable: the chain/cable package is
stainless steel. each package is designed to attach to the
top of the pump and also to the guide plate which is part
of the movable disconnect. each package is designed to
allow the pump to be safely hoisted up the guide rail.
For parts or assistance, call Jung Pumpen Customer Service at 1-800-642-5930
Basin Cover: several types of basin covers are available
for use with either fiberglass or concrete basins. Basin
hatch type covers are available in either steel or
aluminum construction.
Basin Bottom: all cement pipe basins must have a
smooth level troweled bottom for level mounting of the
base plate.
Mo unting Cover and Assembled Rail
Sections
safe installation procedures are the sole responsibility
of the lift system installer. Work safety requirements are
defined in us department of labor 29 CFr part 1926.
1. set concrete cover with hatch opening in position
over basin.
2. lower the assembled rail system into the basin and
attach wall bracket to rail system using supplied
fasteners. Fasten the wall bracket to the side of
the basin. a typical assembly is shown in Figure 1.
48"
48"
36"
Figure 1: SGR125 and SGR200 Typical Assembly
3
1
2
3
2.5"
11"