Denon Professional DN-104S Guia Del Usuario página 4

Installation
To ensure a reliable installation, please follow these steps carefully:
1. Assemble the speaker mounting bracket (see graphic below) by taking one of the alignment beams
and sticking it under the groove in the "C" shaped speaker mounting bracket. Place in the desired
install location and use 2 screws and 2 washers to connect. Repeat this process on the other side
while making sure the holes line up evenly.
2. Determine the speaker position, taking into account any obstructions in the ceiling space. Note that a
clearance of 125 mm above the lower face of the ceiling is required. The cutout diameter is 182 mm.
3. Remove the ceiling space and position the "C" shaped speaker mounting bracket so that it fits the
hole that you cut. Use a metal safety wire with a snap hook (sold separately) and loop it around a
truss/beam on one end. Use a screw to mount the safety wire by fastening the speaker mounting
bracket into the truss/beam that the safety wire is looped around. Make sure the screw head covers
the surface area of the screw hole.
4. Remove the supplied 4-in Euroblock from the speaker and connect it to the speaker cable (see
graphic below).
5. Use the provided loop-through terminals (see graphic below). When this wiring method is used, you
should be aware that when a speaker is not plugged in there is no path to subsequent speakers. An
alternative is to wire incoming and outgoing cables in parallel. Pin 2 is + and Pin 3 is - (see graphics
below).
Parallel
6. Insert the pre-wired Euroblock connector, ensuring the correct polarity is being used.
4
Power Amplifier
Speaker 1
+ -
Speaker 2 Speaker 3
To Subsequent
Speaker