Fondital eCool ED Manual De Instalación, Uso Y Mantenimiento página 39

Pilot wire mode (not active on this model).
In this mode the radiator is controlled by a remote control unit.
Window opening function
The radiator is able to identify whether a window has been opened through detection of a quick ambient
temperature reduction (at least 1.5°C). If this happens, the radiator will switch off for 30 minutes; after
this time has elapsed, the radiator will resume operation in the previously set mode.
When the function is activated the symbol of the window is displayed.
When the function is activated and detected at window opening, the displayed symbol of the window
is intermittent.
When the function is deactivated the symbol of the window is not displayed.
The user can activate or deactivate this function as follows:
1. Switch the radiator to standby state.
2. Press "+" key for more than 3 seconds.
3. The symbol of the window is flashing. Press "+" key to activate (on) or deactivate (off )
the function.
4. Press the function key to confirm your selection and go back to standby mode.
Window opening function activated:
Note: the correct operation of this function depends on the radiator position. If the radiator is positioned
in a way that does not allow the detection of the temperature reduction or where it can be affected by
other heat sources, it is possible that the window opening will not be detected.
Key lock function
It is possible to lock the device to avoid an improper or unintentional use, for instance for children
protection or in a public space.
To lock/unlock the keys, press the B function key for three seconds, the keypad will be locked/unlocked
in the required position.
When keypad is locked, the "+", "-" and function keys are not active. However, it is always possible to
switch from ON to Standby mode and vice versa even with keypad locked, as the lock does not affect
the on/standby key.
Window opening function not activated:
EN
39