Philips Philishave QC5090 Manual Del Usuario página 10

ENGLISH
10
Cleaning
Clean the appliance every time you have used it.
Do not use abrasives, scourers or liquids such as alcohol, petrol or
acetone to clean the appliance.
The appliance and the adapter may only be cleaned with the brush
supplied.
1 Make sure the appliance is switched off and disconnected from
the mains when you start cleaning it.
2 Remove the comb attachment by pulling it off the appliance
(fig. 9).
3 Push the middle part of the cutting unit upwards with your
thumb until it opens and then pull it off the appliance (fig. 10).
Be careful that the cutting unit does not fall to the floor.
4 Clean the cutting unit with the brush supplied (fig. 12).
5 Also clean the inside of the appliance with the brush supplied
(fig. 13).
6 Place the lug of the cutting unit into the slot and push the unit
back onto the appliance ('click') (fig. 11).
This appliance does not need any lubrication.
Replacement
A worn or damaged cutting unit should only be replaced with an
original Philips cutting unit.
Push the middle part of the cutting unit upwards with your
thumb until it opens and then pull it off the appliance (fig. 10).
Be careful that the cutting unit does not fall to the floor.
Place the lug of the new cutting unit into the slot and push the
unit back onto the appliance ('click') (fig. 11).